05-22-2014, 12:21 PM | #1 |
Quarry Creeper Join Date: Mar 2008 Location: Redlands
Posts: 448
| Programming RX8 Gen2
So I finally decided to put my RX8 Gen2 together, and get it setup. Fired up Hotware 2.0, and went to program the ESC. I noticed that the drive mode is set to Dual Drive, and is not changeable, anywhere I can find. I would like to run it in Sensored Mode, if possible. Motor is a Pro4HD 3300 Does the motor need to be connected to the ESC and everything powered up before settings like that show up? (gear is at home, laptop is at work) /rant Could the software for Hotwire 2.0 be any smaller and harder to read? |
Sponsored Links | |
Programming RX8 Gen2 - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tekin RX8 gen2 & Wraith | darkstar | Axial Wraith | 3 | 09-28-2014 06:29 AM |
RX8 Gen2/Pro4HD 3000 in Ultra4 | Hunter711 | Electronics | 1 | 04-27-2014 09:11 AM |
Tekin RS Gen2 on the Wraith | Dreufic | Videos! | 3 | 10-06-2013 04:40 AM |
Tekin RS Gen2 | cytogen | Electronics | 0 | 03-30-2013 03:23 AM |
| |