Multiple rigs on a GT3B/C

[irvan105]

Ok guys and gals. new to the rc still so learning as i go. I searched but couldnt come to a good conclusion. If i have missed the answer somewhere i apologize. I have a wraith and have now gotten into some micro rigs. I had been contemplating upgrading to maybe the GT3B/C. With this could i put the corresponding rx in both rigs and be able to use 1 controller for both rigs( different times obviously)

TIA

[ElChupacabra]

Yes. It has something like 64 model memory. I'm running 8 different vehicles on my GT3C now. Cheap receivers are another bonus for that system.

[spoo76]

Technically it binds to all the receivers and only changes settings for each model. If you had 2 models with the same settings and both were on they'd both run, though it of course would be difficult to control. I did this on accident and was a bit surprised when my other rig started moving haha

Sent from my SM-N900T using Tapatalk

[TooOldForThis]

Originally Posted by irvan105

Ok guys and gals. new to the rc still so learning as i go. I searched but couldnt come to a good conclusion. If i have missed the answer somewhere i apologize. I have a wraith and have now gotten into some micro rigs. I had been contemplating upgrading to maybe the GT3B/C. With this could i put the corresponding rx in both rigs and be able to use 1 controller for both rigs( different times obviously)

TIA

You might have problems if the micro rigs have integrated receivers, like one of those ESC/receiver combos. If that's the case, you would have to get a new ESC to go with the Flysky receiver.