Led lighting help I’m going cross eyed searching. I’m building a power wagon body. I got the powershift lights for the power wagon. I would also like to add a light bar. I’m running the mamba x esc and a 3s battery, a Sanws mt4 radio and 4ch rx. The powershift lights say they recommends 12v power. How can I go about wiring this up? Light controller? Anything that would work with this to also control brake lights, reverse lights? Any help would be great. |
Re: Led lighting help I think I can help. This will let you turn all of your 12 volt lights on and off using a two (or three) position channel: http://www.rccrawler.com/forum/vendo...ml#post3339137 It can take its power from a 3S pack. Ideally, your rig's motor already uses a 3S pack for power and it just gets shared, but if you have to, you can use a dedicated battery instead. This part will operate brake and reverse lights: http://www.rccrawler.com/forum/vendo...ler-%2430.html Let me know if the lights you are going to run are 12 volt and I can make it operate those instead of receiver voltage powered lights instead. This part does what the two previous parts do, plus a little more: http://www.rccrawler.com/forum/vendo...ml#post4435415 Please send me a PM if I can be of further help! Al |
Re: Led lighting help The light product page says the lights Can work on 2s and 3s but better on 3s. |
Re: Led lighting help Sounds good. I would just build the external power versions for you. |
Re: Led lighting help But it wouldn’t control the brake lights or reverse lights and driving lights correct? |
Re: Led lighting help Quote:
|
Re: Led lighting help Pm sent. |
Re: Led lighting help Quote:
I have replied. |
All times are GMT -6. The time now is 11:38 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com