|
| LinkBack | Thread Tools | Display Modes |
04-18-2021, 03:44 PM | #1 |
Newbie Join Date: Jan 2021 Location: Reynoldsburg
Posts: 1
| Need help y’all don’t know what going on
I installed this chassis w/ driveline from https://www.integy.com/st_prod.html?...9#.YHyizWT3YWNintegy and came with no instructions first time doing something like this but when I try to drive it it buckles or just doesn’t run not sure if I put the driveshafts in the wrong place or what I did any help is appreciated Video- https://imgur.com/a/RxrE43W Sent from my iPhone using Tapatalk |
Sponsored Links | |
04-18-2021, 04:26 PM | #2 |
I wanna be Dave Join Date: Oct 2010 Location: Caldwell ID.
Posts: 4,328
| Re: Need help y’all don’t know what going on
Watching your vid, I don't think its a electronics issue. First thing I would do is remove your drive shafts, and try to roll the truck by hand. If it rolls freely, You know it is not the axles. If not you can go further by trying to roll each end of the truck. Second thing if your axles check out is to check the drivetrain. Remove the pinion fro the motor and try to spin the trans and transfer case. If that checks out put first one driveshaft on then the other... My suspicion lies here, with how short the wheelbase looks and how big your tires are. |
04-19-2021, 09:34 AM | #3 |
RCC Addict Join Date: Jan 2016 Location: Kelowna, BC
Posts: 1,274
| Re: Need help y’all don’t know what going on
Just by studying your video and that picture it looks your Tcase is installed backward and the driveshafts are hooked up wrong. Looks like you need to: Spin the Tcase 180* (the side with the shafts spaced wider apart should face the motor) Dshaft going into Tcase (from the motor) should come from the D side and cross over to the P side The outputs should be easy to figure out once that's sorted out. Hard to say much for sure just by looking at one marketing picture and a short/shaky video but that's what it looks like to me.. |
04-20-2021, 02:26 AM | #4 |
I wanna be Dave Join Date: Feb 2017 Location: My mothers basement
Posts: 2,128
| Re: Need help y’all don’t know what going on
The problem is your shocks are installed wrong, this puts too much angle on those drivelines. Set a brick on the car to compress the shocks and it will be smooth. |
Need help y’all don’t know what going on - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
What I don`t plan on doing again | Hards1.6 | Axial Wraith | 4 | 06-25-2012 04:52 PM |
An injustice has been don!!! | DKSnipes | New Mexico | 24 | 03-22-2009 05:33 PM |
| |