Flysky GT3B and a Winch Need Help I have a hacked GT3B, a RC4WD winch and their wired winch controller. I have it hooked to channel 4 on my receiver and set to work of the D/R switch. I have it set for momentary control. My problem is it works fine going out. Press the button forward towards front off control and winch spools out. Problem is spooling in. First off it will just start spooling in on its own. I can press the switch towards the spool out position and it stops but soon after starts spooling in again. Also, the momentary in doesn't work. If I press the switch to spool in it runs non stop until I press the switch the opposite direction towards spool out. I'm not real up on this stuff yet, but I've been though all the settings I can find and can't figure it out. Anyone have any ideas? Thank you. This is the controller I'm using https://store.rc4wd.com/RC4WD-Wired-...it_p_3725.html |
Re: Flysky GT3B and a Winch Need Help https://www.heyokperformance.com/Win...3_1588136.aspx Check here first if you’re considering a new controller. Sent from my iPhone using Tapatalk |
Re: Flysky GT3B and a Winch Need Help Quote:
Sent from my Pixel 6 Pro using Tapatalk |
Re: Flysky GT3B and a Winch Need Help it sounds like a radio problem i would go back and reset the buttons and try again ive had issues with some escs the nutral settings seem to migrate so i have to adjust the throtle trim it seems to do it more after running slot of different rigs some times if i turn everything off and back on a few times it fixes its self the gt3b and Cs are gletting old they ware out and at best need to be recalabrated every now and again your winch controler is basicly a cheap esc and most likely has its own calibration proccess its possable a new winch controler will work better with that radio but really there is no way to know i would remap the button and calibrate the radio and see if it dose anything also try a different button see if that helps some times alittle wd40 helps too ive had the buttons get sticky too |
Re: Flysky GT3B and a Winch Need Help Quote:
I asked about winch controllers here a while back and everyone told me to stay away from the rc4wd one and get that heyok controller. It’s what I’m running and it works well, no creep. Just a suggestion, I’m sure lots of people are happy with the same one you’re using. Sent from my iPhone using Tapatalk |
All times are GMT -6. The time now is 06:56 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com