Re: what servos are yall running ..... DO NOT USE THE HS-5645MG!!! They suck for what we do! |
Re: what servos are yall running ..... Quote:
|
Re: what servos are yall running ..... best place to purchase and cost of these servos is what? L.R. |
Re: what servos are yall running ..... i get mine off rpp hobby. sometimes there on flea bay for a lil bit cheaper |
Re: what servos are yall running ..... |
Re: what servos are yall running ..... Savox SA 1230 --500 oz. $75.00"thumbsup" |
HiTec 7954 7955 7950 yoda4x4 |
Re: what servos are yall running ..... So I figured out what happened to my old Solar 772........ Watta!!!!:twisted: Yup, I didn't get it waterproof enough. So with that being said I'm gonna give them another shot, only this time I ordered a backup just incase I screw it up again...... Better to learn how to wproof on cheap servos than expensive ones....:lmao: Oh by the way, the old 772 didn't go to waste, I was able to salvage the motor and apply another board and fab up a winch.... |
Re: what servos are yall running ..... Looking through this thread and stumbled upon this CYS S8218 Digital 6V 7 2V 0 18SEC 60°A 164g Metal Gear 40kg High Torque Servo | eBay This 40kg cm converts to about 555oz in! Anyone have any experience with them? |
Re: what servos are yall running ..... Hello. I´m looking for a good servo for my scx10 and for my wrait "all condition edition" Caution! the CYS S8218 have very big dimmensions for our crawlers. 60x29x55mm Thanks. Merry Christmas |
Re: what servos are yall running ..... Since learning how to to waterproof better I have had no problems with my solar servos. The only down side is that they are a little noisey. I have not put a BEC on my rig yet. |
Re: what servos are yall running ..... Just slapped a D772 on my SCX10 along with a BEC at 7.4V. Havn't waterproofed yet, but plan on it (I've got 3 others, 1 for a winch, one for a rig that's in the mail, and a spare) I can't report how the servo does though yet as i've only taken it around the parking lot at my apt. |
Re: what servos are yall running ..... Quote:
Good servo for the price but pulls some volt's so use a BEC and that thing is a monster I had one in my comp rig.... |
Re: what servos are yall running ..... Quote:
I ended up completely covering the circuit board with die electric grease and liquid electric taping/oring the outer housing. Have had no problems with it yet. 2 comps and many trail rides. |
Re: what servos are yall running ..... Even just in the parking lot (and inside on the carpet) the D772 is a HUGE improvement over the Traxxas 2075 it's replacing. Went with a chassis mounted servo and the Traxxas wasn't up to the task of turning left anymore. I'll be removing the AS-3 servo as well as soon as the Deadbolt comes in lol |
Re: what servos are yall running ..... Anyone know which programmer is for the hitec 7955th? |
All times are GMT -6. The time now is 10:16 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com