|
| LinkBack | Thread Tools | Display Modes |
12-12-2013, 04:48 PM | #1 |
RCC Addict Join Date: Feb 2012 Location: Ca.
Posts: 1,580
| ScalerFab skid plate install
So after cleaning up the skid plate and getting rid of some sharp edges, it was time to remove the Gmade skid from the Sawback. You'll have to loosen the bolts holding the battery tray and electronics box so you can spread the frame rails enough to drop the skid. Next it was time to test fit the plate. All of the holes lined up fine after a little adjustment. Transmission mounted to skid plate. What's nice about this plate is that it mounts to the outside of the frame rails. No more spreading of the frame rails. Not to mention the added ground clearance. Next, install the plate, tighten the bolts on the skid plate, battery tray, and electronics box and you're done. As you can see I am running the Axial drive shafts. In this last photo I tried to show the clearance between where I have my ESC mounted and the joint on the shaft. Those of you running the stock drive shafts MAY have to do some trimming of the electronics plate. I did not test the clearance with a stock drive shaft. All and all a very easy install. The ScalerFab skid plate is made well. The welds were good and the holes in the plate matched perfectly with the frame rails and the transmission. And no more skid plate hanging below the frame rails to the extent the stock one does. A test run on the rocks put a big smile on my face. Last edited by raceeng18; 12-12-2013 at 05:48 PM. |
Sponsored Links | |
12-12-2013, 06:24 PM | #2 |
Quarry Creeper Join Date: Feb 2010 Location: Woodland Park, CO
Posts: 331
| Re: ScalerFab skid plate install
Nice write-up. I have it mounted on my Sawback with the stock shafts with no interference... |
ScalerFab skid plate install - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Measurements for stock AX10 Transmission mounting plate/skid plate | Apoch | Axial AX-10 Scorpion | 5 | 04-09-2012 07:53 AM |
skid plate | al3x_34 | Axial Wraith | 2 | 09-08-2011 12:03 PM |
VP Case/Plate Install | meffie | Axial XR10 | 17 | 01-10-2011 06:06 PM |
AX-10 skid plate | liltexmp | Axial AX-10 Scorpion | 1 | 04-15-2008 07:39 AM |
| |