My first crawler Never build one before. Always wanted one so here it it. Full droop set-up 2.5" belly clearance 80% Anti-squat/Anti-dive front and rear Less then 1% over steering (flex steer) 3.875" Roll center Body is 2.75" wide Here are the specs: -I designed the chassis on Solidworks had it laser cut. -The skid plate is 3/8" Delrin -Tranny is AX10 -Motor is an Integy 55T -Gears are 87 tooth and 14 tooth No Slipper (no idea the names, spur and pinion i think) -MIP drive shafts -Heavily modified RC4WD shocks (jato Shock lower flex joint, Traxxas small upper flex joints, Airtool oil) -AX10 Axles -6 cell 1800 MAH split pack (will soon switch to LIPO's) -AX10 Spoked rims -Servo is hitech 645. Items yet to be installed/arrive from random people around north america -Rooster crawler -TQ3 Remote / receiver -Losi rock claws This build was done on a budget, some items are not the best but will eventually swap out. I have Delrin that i will be making lower links later on. Enjoy http://img.photobucket.com/albums/v2...c/IMG00050.jpg http://img.photobucket.com/albums/v2...c/IMG00051.jpg http://img.photobucket.com/albums/v2...c/IMG00053.jpg http://img.photobucket.com/albums/v2...c/IMG00054.jpg http://img.photobucket.com/albums/v2...c/IMG00055.jpg http://img.photobucket.com/albums/v2...c/IMG00056.jpg http://img.photobucket.com/albums/v2...c/IMG00057.jpg http://img.photobucket.com/albums/v2...c/IMG00058.jpg |
Looks good! I really like when people design their own parts, especially their chassis! |
Holla! You should repost this in the ax-10 section. |
Nice start. Chassis looks pretty sweet. |
Nice job Kraqalacka. "thumbsup" |
All times are GMT -6. The time now is 06:35 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com