GC2 cobalt 7t Any one put a cobalt motor in the gc2? will it fit? |
I might be wrong but if memory serves me right it won't fit. |
Thanks. on the holmes hobby web site its says its 2.5 inches long. Is that the motor or the shaft? What a measurement so i can figure it out? |
2.5 endbell to endbell |
That is the motor length not including the shaft."thumbsup" |
Anyone have a gc2 and know if it will fit or not? I think it will be really close |
it will with some very careful grinding on the chassis and back end bell. take your time i think it took me about an hour to do grind check grind check. dont make it to thin at the bottom this is the only pic i have of it http://i125.photobucket.com/albums/p...8/DSC05383.jpg |
It will fit, but like jeepcj578 said, take your time and only remove the smallest amount. http://farm4.static.flickr.com/3588/...82507f59ee.jpg http://farm4.static.flickr.com/3252/...4106e430c7.jpg http://farm4.static.flickr.com/3298/...20c56b0716.jpg By the way, that was a 7T puller and it would get much too hot on 3S so I sold the motor. Great power, wheel speed and low speed resolution though for the short time it was in there. |
All times are GMT -6. The time now is 03:43 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com