Turning a Hitec 5645mg into a winch... but.... I think something is wrong.... I followed the steps that the guys at my LHS gave me, put it all back together and plugged it into the steering slot on my rx just to test it and it doesn't spin freely. it still turns like a steering servo... Left...Stop. Right...Stop. release, centers. Is it behaving this way because it's hooked into a steering slot? |
Re: Turning a Hitec 5645mg into a winch... but.... Sounds like you didn't get the limiting pin out of the main gear. The fact that it is connected to the steering channel makes no difference. Give this a read, explains everything pretty visually. http://www.rccrawler.com/forum/elect...-tutorial.html -Jon |
Re: Turning a Hitec 5645mg into a winch... but.... You need to get a heyok winch controller. Here's a link for what you need. You will also need to remove the circuit board and pot. Just solder the wires to the motor in the servo plug in to your rx and your good to go. Don't forget a bec so you can regulate your voltage to 6 volts. There are good write ups on here for what you need to do just search for it. HeyOK Winch Controller for Radio with Two Position Channel |
Re: Turning a Hitec 5645mg into a winch... but.... i removed the limiting pin from the gear with the output shaft, I didn't think swapping the controller would be necessary... I thought that was only necessary if you experience winch creep. |
Re: Turning a Hitec 5645mg into a winch... but.... Maybe a stupid question...did you center and glue the pentometer? - |
Re: Turning a Hitec 5645mg into a winch... but.... potentiometer is centered and the output shaft gear is glued to it, just like the guy at my lhs told me to do. |
Re: Turning a Hitec 5645mg into a winch... but.... double check this thread to make sure you did everything right. I have done this mod multiple times and never had this issue. I have never glued the output gear to the pot. http://www.rccrawler.com/forum/gener...ild-winch.html btw...this should be in electronics;-) - |
Re: Turning a Hitec 5645mg into a winch... but.... I will say though, the best way IMO to do this mod is with a Heyok. With your method the servo WILL creep on you even if you get it perfect, after some good use. No glue, no fuss, no creep and high voltage...Heyok all the way"thumbsup" - |
Re: Turning a Hitec 5645mg into a winch... but.... You need to have it installed on a 3 pos channel on your rx, which would give it out, stop, in. A steering or throttle channel is not capable of that "stop" signal. |
Re: Turning a Hitec 5645mg into a winch... but.... For $5 more heyok states he can do it with a 2 pos 3rd channel if you dont have a 3 pos |
All times are GMT -6. The time now is 01:15 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com