Not sure if the titles right but I have a rc4wd r2? 2 speed trans. My question is instead of trying to trade it for a scx10 trans can I just remove a few parts and make it a single speed? I know rc4wd makes it in a single speed(sorry if that's the wrong term) but I was wondering if I can pop off this part. http://i1097.photobucket.com/albums/...si6irnfar.jpeg And then replace it with the normal non 2 speed trans gear? If anyone has experiance with these i would greatly appreciate the info. I figured since this one already has steel gears and te new part I'm looking at would be same price as shipping it out for a trade and would be good for what I need. Thanks again for any help guys"thumbsup" Also I'm very new to anything rc4wd but the more I check it out it seems like it's a dig transmission and not 2speed. Thanks again. But either way I'd like to remove it and make it a normall trans without any servos on it(personal thing) Also here a pic of the inside. Seems like it will be a once I commit project there's no going back easy. http://i1097.photobucket.com/albums/...sebxhbhyi.jpeg |
Re: Turning 2 speed trans into single speed Just lock it into one position and its done. For my TF2 transmission I used a turnbuckle with a rod-end on each side, turning a two speed into a single. |
Re: Turning 2 speed trans into single speed Will do. And that way if I ever get the urge to run the dig I can. Thank you for the advice and the tip. |
All times are GMT -6. The time now is 06:03 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com