| |
11-03-2021, 08:49 AM
| #1 |
| Quarry Creeper Join Date: Dec 2009 Location: Central IL
Posts: 282
|  Hurtz Dig V2 Parts
The set screw backed out of the drive dog on my Hurtz dig and got into the housing as it was spinning. It deformed the hex so much that I can’t get a tool in it so the set screw needs replaced. I tried m2, m3, and 4-40. None of them fit. I emailed Vanquish to get the thread size but they haven’t responded. Does anyone know the thread size for the set screw that fits this part?  |
|  |
| Sponsored Links | |
| | |
|
11-03-2021, 09:30 AM
| #2 |
| Rock Crawler   Join Date: Dec 2012 Location: Utah
Posts: 955
| Re: Hurtz Dig V2 Parts
Either 1/16 or .050 wrench, might be smaller than those 2 sizes as well
|
|
| |
|
11-03-2021, 10:13 AM
| #3 | |
| Quarry Creeper Join Date: Dec 2009 Location: Central IL
Posts: 282
| Re: Hurtz Dig V2 Parts Quote:
| |
|
| |
|
11-05-2021, 12:30 PM
| #4 |
| Quarry Creeper Join Date: Dec 2009 Location: Central IL
Posts: 282
| Re: Hurtz Dig V2 Parts
Following up for anyone who may find this while searching. I obviously need to step up my set screw game, so I ordered a metric assortment to keep on hand. M2.5 threads in beautifully. Pretty sure it has a 1.3mm hex, but .050" fits it pretty well. 1.3mm is .052", so it's really close anyways. I'm good to go now! |
|
| |
 |
| |
Linear Mode
