IFS/Wraith TW
 

Im looking for a IFS setup thats the same track width as a wraith axle, anybody have any ideas?

slash 4x4? lst?

HPI MT2 for the win. Even uses the same gear ratios.

yeah my vote is on the HPI MT2 diff and arms "thumbsup" ....i have that set up in my pro 4 SCT build and was gonna go with the RC4WD short course rear axle, but now i'm going with a wraith axle instead "thumbsup" ..........bob

....

I have an HPI MT2, but it looks like it would be too wide? do you have a build thread on that?

yeah it is over on rcshortcourse forum "thumbsup" ........bob

http://www.rcshortcourse.com/forum/g...dy-launch.html

....

I vote for the EXO front end myself... why not keep it all Axial?

I know, I know.. not available but will be soon...

Hmmm, i didnt know that was the same width. Does it use the same Ring/Pinion as the Wraith?

My slash 4x4 front clip on my trophy truck is 9.75" wide, hex to hex. http://www.rccrawler.com/forum/non-c...-videos-6.html
Wraith axle hex to hex is 9.57". Darn close. I run a wheely king rear axle cause the diff is centered. The Wraith is offset.

That looks like its gonna be bada$$ "thumbsup"

thx, if ya caught my tigress build along with my TT build well yeah it will be bada$$ "thumbsup" .........bob

....

I saw your TT build but not the other one.

you would think axial are awere how popular this set up would be and have already got the kit to add the exo front end to the wraith.if not they will miss out on some $.the first one to offer to the masses a kit to do this will make plenty of $.i hope DMG read this

After doing some investigating ive found out that the EXO uses the same Ring/Pinion as the AX10/SCX10 and Wraith.

So it looks like i might be using that :twisted:



When it comes out that is...