Black Widow Axles - MiniMill has been busy I picked up a set of Black Widow axles from TheSaundo (thx!!) without mounts or truss'. Then found out it was $70 for the lower link mounts :roll: Upper link mount doesn't exist. I thought of brazing up some stainless, but these axles are so beautiful and angular I wanted to stay with the angles versus tubes. Then thought about milling some delrin, but silver would look better. Landed on some milling some alum. My mini mill takes a long time with what carbide and high speed steel bits I have. So far I have the rear truss and lower link mounts completed. Lower link/shock mounts slide over axle tubes and pinch clamp in place. Truss has two screws into beefy pumpkin and one down through the pinch clamp , into the axle tubes (anti rotation). Truss has slot for third link, with a panhard mount out at the end. The Black Widow axles allow for:
pics so far............... http://i425.photobucket.com/albums/p...tassembled.jpg http://i425.photobucket.com/albums/p...assembledB.jpg |
Re: Black Widow Axles - MiniMill has been busy My Sherline mill is purely manual and not schooled in millwork, so some dims and angles are off a little. Angles are eyeball aligned when clamped:shock: http://i425.photobucket.com/albums/p...rAxleTruss.jpg http://i425.photobucket.com/albums/p...AxleTrussB.jpg http://i425.photobucket.com/albums/p...AxleTrussC.jpg |
Re: Black Widow Axles - MiniMill has been busy Looks awesome, your milling work looks great also, can't wait to see the final assembly running on the trails |
Re: Black Widow Axles - MiniMill has been busy Thanks Joe!! One of those lllooonnngggggggggggggggg slow builds. |
Re: Black Widow Axles - MiniMill has been busy Those were a set of axles I sold to him and honestly I wish I would have kept them instead of the set that had factory mounts..believe me the rc4wd mounts have much to be desired especially the top mount..:roll: The other set I kept was a real pain to get mounted up on a 3 link panhard setup and no matter how I set them up the panhard bar mount(upper mount) bottoms out on the ball link. Your ahead of the game machining your own "thumbsup" |
All times are GMT -6. The time now is 05:15 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com