12-08-2009, 05:54 PM | #1 |
Rock Crawler Join Date: Jan 2008 Location: Calgary Crawlers, Alberta, Canada
Posts: 617
| Micro help.....
I shortened my servo wire and want to put the ESC in heatshrink but I forgot which way the plug goes. Can someone post a picture of their servo plugged into the ESC (with or without the case) so I can be sure before I heatshrink it? Also, the wires came off my motor while I was working on it, could someone post a picture of their motor with a clear view of where the blue and orange wires solder to the motor? Thanks for the help, I searched the picture thread on here and google but can't find a detailed picture. . |
Sponsored Links | |
12-08-2009, 06:18 PM | #2 |
Rock Crawler Join Date: Aug 2009 Location: Sandy Oregon
Posts: 517
|
On your motor the top is orange the bottom is blue. The servo plug should go in with the black wire to the outside pin |
12-08-2009, 06:18 PM | #3 |
Newbie Join Date: Dec 2009 Location: Indianapolis
Posts: 45
|
servo should go with the notch side up, yellow red black from left to right on the pins. so black red yello going from the swith. (im guessing) motor, the open side of the can (not sure if both sides are open), left (top installed) orange wire, right (bottom post installed) blue. the orange should be on the same side the number stamped on the can is on |
12-08-2009, 06:43 PM | #4 |
Rock Crawler Join Date: Jan 2008 Location: Calgary Crawlers, Alberta, Canada
Posts: 617
|
Thanks for the help guys. Before I seal it up, like the pictures below? |
12-08-2009, 06:47 PM | #5 |
Newbie Join Date: Dec 2009 Location: Indianapolis
Posts: 45
|
yea, by going off the stock losi servo the brown was closest to the switch, notches being on the top. id assume the colors (brown being neg) would be the same location on your hitec.
|
12-08-2009, 06:59 PM | #6 |
Rock Crawler Join Date: Dec 2008 Location: Marengo, Ohio
Posts: 980
|
Im runnin a hitec and the way you have it painted is correct.
|
12-08-2009, 07:06 PM | #7 |
Rock Crawler Join Date: Jan 2008 Location: Calgary Crawlers, Alberta, Canada
Posts: 617
|
Thanks everyone, a little solder and heatshink and I'll be back crawling cardboard in no time.
|
| |