how do you remove the transmission from skid plate? I bought the gatekeeper chassis for my MRC and took the stock one all the way down to the transmission/motor combo from the skid plate. It looks like a rivot. Is it a tiny freaking torqs bit? Again its the fasteners on the bottom of the skid plate that holds the tranny. Thanks in advance. |
you need a 1.5 mm hex driver to remove the screws"thumbsup" |
Just make sure that you use a good quality wrench or you'll round the hex hole and that ain't good. Same with the front and rear servo plates, as I know to my cost, so take care. |
x2 on the quality tool, I used the cheap one that came with my mini. Instead of rounding the screw, though, I rounded the hex. Kept cutting it down until I pretty much don't have a tool.:shock: Speaking of which, I should go buy a new one!:roll: |
All times are GMT -6. The time now is 07:55 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com