Losi micro high roller I was wondering if any of you knew if you could fit 1.0 wheels and tires on a high roller? what about orlandoo hunter whell and tires? also curious if you knew of anybody that still has some of the gpm aluminum hop up parts? |
Re: Losi micro high roller Cheap fleaBay, AsiaTees, and maybe Amain for the hop ups. As for fitting different wheels it's not that easy. The front wheels on the H.Roller aren't a hex or pin, they're pressed in bearings that the shaft slides into. Just like the Losi Mini. |
Re: Losi micro high roller Quote:
|
Re: Losi micro high roller Those black chrome will fit. They're for the Micro DT and are a little smaller. There are a set of axles that have a small plastic but instead of the E clip that's a lot easier to deal with. The Orlandoo tires wont be wide enough for the wheels. |
Re: Losi micro high roller The best bet would be to buy a Losi Micro already hopped up and either use it as a parts donor or use it. |
Re: Losi micro high roller here's a little project that I did with my micro high roller: http://www.rccrawler.com/forum/micro...-explorer.html they way that I made 1.0 tires work was by getting a set of micro DT wheels/tires and just gluing them into the 1.0 wheels. check towards the bottom of my post and you can see what I mean. they're not perfect but if you're not looking from super close it's pretty good. |
Losi micro high roller The cheap foam grips for a bicycle handlebar makes good indoor hard surface drift tires. All I could find before I gave up were yellow. https://uploads.tapatalk-cdn.com/201...c44d216479.jpg |
All times are GMT -6. The time now is 02:21 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com