| |
04-06-2008, 02:47 PM
| #1 |
| Rock Crawler Join Date: Feb 2008 Location: Nebraska
Posts: 819
|  More questions
Hey Guys, I posted in the "Newbie" section yesterday afternoon and haven't gotten any replies. Receiver causing shutdown? Maybe I should have posted under electrical . . . . . There seems to be an issue with running my new radio/receiver in my truck. Any suggestions? Thanks, |
|  |
| Sponsored Links | |
| | |
|
04-06-2008, 04:33 PM
| #2 |
| RCC Addict Join Date: Nov 2007 Location: in the woods
Posts: 1,915
|
It sounds like a mixture of interference and maybe the radio end points are off. Try putting the 403 setup back in your truck, follow all the instructions that comes with the radio, and then set up your ESC in accordances with the Novak manual. If you are still having problems, call me....
|
|
| |
|
04-07-2008, 06:05 AM
| #3 |
| Rock Crawler Join Date: Feb 2008 Location: Nebraska
Posts: 819
|
Hey Gerame, I went back through and reconfigured everything like you suggested. So far it's working fine now. Changing the servo type from UNI to MPX seemed to make it a lot happier (the book doesn't explain the difference) I hope that was the correct thing to do. Right now I have the 65t motor in it. I'll have to put the 17t back in and test with that too, just to make sure that it's all working fine. Thanks, |
|
| |
 |
| |
Linear Mode
