| |
02-17-2014, 06:47 PM
| #1 |
| Newbie Join Date: Feb 2014 Location: tunnel hill
Posts: 1
|  help needed
ok im new to the crawler so bare with me. i got my first crawler today, a redcat rockslide rs10xt its ok , the problem is how do i set the control back to factory settings my daughter got it while i was outside on phone now nothing works or responds right the specs are radio system 2.4ghz3 channel transmitter. it was running great before this happened or is their away to restart the receiver and transmitter |
|  |
| Sponsored Links | |
| | |
|
02-17-2014, 11:47 PM
| #2 |
| RCC Addict Join Date: Jun 2008 Location: In the woods
Posts: 1,155
| Re: help needed
New?It has instruction manual right?
|
|
| |
|
02-18-2014, 04:42 PM
| #3 |
| Pebble Pounder  Join Date: Feb 2014 Location: gladwin
Posts: 106
| Re: help needed
If no manual call red at tech support there should be a reset button on the esc but then you will have to reprogrammed the rx and TX buy reminding them and walking through beeps and lights on the esc. CALL RED CAT tech support to walk you though it.
|
|
| |
|
02-18-2014, 05:32 PM
| #4 |
| RCC Addict Join Date: Jun 2008 Location: In the woods
Posts: 1,155
| Re: help needed
Their tech support # is 6024546445 |
|
| |
 |
help needed - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what is needed for this | WestTxRc | Electronics | 6 | 11-24-2011 04:27 PM |
| I can't believe I am asking this!! Help needed! | mpkelley20 | Axial AX-10 Scorpion | 5 | 09-02-2010 04:00 PM |
| |
Linear Mode
