|
| LinkBack | Thread Tools | Display Modes |
06-17-2017, 02:22 PM | #1 |
Newbie Join Date: Jun 2017 Location: South Jordan
Posts: 23
| Castle BEC 2.0 wire questions
Newb question: The waterproof Castle BEC 2.0 has two sets of wires on the output side: +/- And +/-/signal I'm assuming that if I'm using the Holmes RX y-adapter where I don't need the signal wire, I can just use the +/- pair (signal gets passed directly from the RX). Or can/should I use the +/-/signal and the signal wire gets ignored? Does it make a difference? Thanks for your time. |
Sponsored Links | |
Castle BEC 2.0 wire questions - Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how do I wire/solder a Castle 10A BEC to an AE-2 esc, to run 3S LiPo? | ussprinceton2004 | Electronics | 9 | 02-09-2012 02:18 AM |
how to wire a single fxr punk dig and castle bec | krazycrawler888 | Electronics | 5 | 09-19-2011 10:33 PM |
castle bec? what does the signal wire do? | driftin90 | Electronics | 2 | 07-19-2009 05:16 PM |
Castle Link/Bec Questions???? | BMFOTP | Electronics | 12 | 05-17-2009 09:33 PM |
quark 33 and castle BEC. remove esc power wire? | dieselfuel | Electronics | 2 | 03-21-2008 12:12 AM |
| |