| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
02-08-2007, 12:40 PM
| #1 |
| Newbie Join Date: Aug 2006 Location: Niagara Falls
Posts: 10
|  Question about motor wiring
I'm planning on building an NN super crawler after I finish my 2.2 tlt. I was just wondering when you run motors on the clod axels do you have to reverse the timing on one motor, or do you just reverse the motor wires and run the motor backwards?? I've done a bunch of searching on this site but cant find the anser I'm looking for. Any help would be greatly appreciated! |
|  |
| Sponsored Links | |
| | |
|
02-08-2007, 12:43 PM
| #2 |
| Rock Crawler  Join Date: May 2006 Location: Surrey, BC, Canada
Posts: 870
|
That would depend on what motors you're going to use... If you're using lathe motors, then no timing needs to be adjusted... Just wire the one in the rear backwards... Lathes have 0 degrees timing... If yer gonna use motors that're timed beyond 0, then the rear endbell will need to be flipped 180 as well as wired backwards... That's it... |
|
| |
|
02-08-2007, 02:03 PM
| #3 |
| Newbie Join Date: Aug 2006 Location: Niagara Falls
Posts: 10
|
Awesome, that totally ansered my question!! Thanx daviolentone!! |
|
| |
|
02-08-2007, 07:11 PM
| #4 |
| Rock Crawler Join Date: May 2006 Location: Surrey, BC, Canada
Posts: 870
|
No problem, dude... Glad I could help...
|
|
| |
|
| |
Linear Mode
