RCCrawler Forums

cwneuwirth · 12-31-2009, 12:43 PM

I'm getting my Super built up and was wanting your guys thoughts on the posted question. Most I've seen are running 50-55T. I can use 10 tooth pinions to gear it down a little, but am worried about heating the motors up. I'm running Plowboys on HPI Blast rims, maybe 6oz in the front wheels, 3oz in the rear. I'll be using dual sidewinders, and 3S 2200mah lipo. Any help would be appreciated.

Culetto · 12-31-2009, 10:37 PM

i wish i could run pullers on my 2.2 bullies

RC4WD is releasing a 65:1 gearbox they will make running those much easier. Remember thought you arent running it more than 5-7 minutes on course but if they are still heating up in that time you want to be careful. Those motors arent cheap.

12-31-2009, 12:43 PM	#1
cwneuwirth Quarry Creeper Join Date: Mar 2007 Location: Kerman, Ca Posts: 240	10T Pullers on Super Bully axles? I'm getting my Super built up and was wanting your guys thoughts on the posted question. Most I've seen are running 50-55T. I can use 10 tooth pinions to gear it down a little, but am worried about heating the motors up. I'm running Plowboys on HPI Blast rims, maybe 6oz in the front wheels, 3oz in the rear. I'll be using dual sidewinders, and 3S 2200mah lipo. Any help would be appreciated.

12-31-2009, 10:37 PM	#2
Culetto RCC Addict Join Date: Jul 2008 Location: Sin City Posts: 1,332	i wish i could run pullers on my 2.2 bullies RC4WD is releasing a 65:1 gearbox they will make running those much easier. Remember thought you arent running it more than 5-7 minutes on course but if they are still heating up in that time you want to be careful. Those motors arent cheap.

Sponsored Links

RCCrawler Forums

Thread: 10T Pullers on Super Bully axles?