servo clearance?? How far can you grind the axle tube on bully lightweight axles for servo clearance? |
Re: servo clearance?? I filed mine down to the bolt holes, I have a picture of it on my thread. I could have gone further but it was just enough with room to spare. |
Re: servo clearance?? I have had no issue with going all the way to the bore exposing the axle a little. Still plenty of meat in them if they are not turned down. |
Re: servo clearance?? I don't know how I feel about going all the way into the bore of the axle, I would think dirt and all kinds of stuff would end up in there. That would be the easiest thing to do for clearance of the servo. I like the idea of going down to the first bolt holes better, but idk if that will give me the clearance I need for the 7980 servo. It's just a little nerve racking to take a grinder to a set of new axles. Thanks for the input. |
Re: servo clearance?? It's a little strange at first, but gets easy-er, trust me "thumbsup". You'll be cutting off gear box cases in no time, grasshopper. :mrgreen: |
All times are GMT -6. The time now is 08:09 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com