| |
12-25-2017, 12:59 PM
| #1 |
| Newbie Join Date: Dec 2015 Location: Tucson Arizona
Posts: 1
|  rs10 upper link bolt
How do you remove the upper link bolts?  Sent from my SM-G920V using Tapatalk |
|  |
| Sponsored Links | |
| | |
|
12-25-2017, 03:01 PM
| #2 |
| RCC Addict Join Date: Feb 2016 Location: Santa Maria, CA
Posts: 1,751
| Re: rs10 upper link bolt
They are loc-tited in, so you can hold the tip of a soldering iron to the bolt to liquify the loctite, then hold the shoulder of the ball with some pliers while you unscrew the screw. You can try to hold the ball with pliers without heating things up, just be extra careful not to strip/twist off the head of the screw. If you just want the link out of the way while working, you can leave the ball attached and pop the plastic part of the rod end off of it, or just take out the 2 screws that hold the upper link mount to the axle housing. |
|
| |
 |
rs10 upper link bolt - Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| converting to 4 link advice & upper link length | DTA510 | Axial SCX-10 | 7 | 02-04-2017 09:47 AM |
| upper link length for honcho with 4-link truss | 2500hdon37s | Axial SCX-10 | 19 | 08-04-2012 08:46 PM |
| upper link lengths for SCX10 with stock four link | oscodawave | Axial SCX-10 | 4 | 11-19-2010 08:23 PM |
| Can you run an upper link plate with a 4-link? | goldmember | Axial AX-10 Scorpion | 5 | 10-18-2008 08:58 PM |
| Using an T-Maxx upper a arm for a upper link | gregrocks90046 | Tamiya TLT Crawlers | 0 | 08-01-2005 04:01 PM |
| |
Linear Mode
