Everest 10 axle shafts? My front dog bones are slipping. Is there an upgrade shaft. I already have the axial lockers. |
Re: Everest 10 axle shafts? What do you mean slipping? They shouldn't be unless the diff is stripped or you took off too much material when doing the mod. Unless, they're slipping out of the drive cups? Sent from my SAMSUNG-SM-G900A using Tapatalk |
Re: Everest 10 axle shafts? They are slipping at the drive cups |
Re: Everest 10 axle shafts? Quote:
If not and you have play at the stub axle while it's stationary and straight, you could try shimming it on the back side (nearest the drive cup). But, you don't have much room to play with their. Otherwise, you could shim the ankle itself pulling it out to the drive cup a bit. A few options there. Hope that helps. Sent from my SAMSUNG-SM-G900A using Tapatalk |
Re: Everest 10 axle shafts? So there are not axial cva or universals that i can make work |
Re: Everest 10 axle shafts? Gen7 cv axles are a direct fit but since you have an axial locker you would have to mod them to fit. Axial shaft with work might need some bearing if there is any difference in ID of bearings and OD of axle shaft. As you will need to shim the axle shafts. Redcat made a long side and a short side and the axial shafts are both the same length but you need to shim the long side to help with in and out play. |
Re: Everest 10 axle shafts? Yep. There are. Sent from my SAMSUNG-SM-G900A using Tapatalk |
All times are GMT -6. The time now is 04:36 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com