Scale dimple tool Yes, the easiest way to make a scale dimple.. Using : - 8mm Deep Socket Nut Bit. - 6mm flat countersunk screw. - 6mm drill bit for making hole. - Any size vise needed. https://imagizer.imageshack.com/v2/8...922/19AHj7.jpg https://imagizer.imageshack.com/v2/8...922/mVPRd0.jpg https://imagizer.imageshack.com/v2/8...923/cpq3j6.jpg https://imagizer.imageshack.com/v2/8...922/sSv0Ge.jpg https://imagizer.imageshack.com/v2/8...922/XOiN9a.jpg https://imagizer.imageshack.com/v2/8...922/pj2DNT.jpg Socket nut, screw and drill bit just my preference, you can choose your own favorite size. The cons is the sheet will slightly bend, I still need to figure out to make more flat. deephis |
Re: Scale dimple tool Amazing!! Maybe try heat so it only bends at the simple? Soften it up? Maye thicker sheet too? I really like this technique! The dimples on the enduro sliders always make me with they were real. |
Re: Scale dimple tool I did similar on a bumper I made a year or 2 ago, but instead of using a socket, I made a counter sunk hole in a piece of wood as 1/2 of the die with a 6mm countersunk bolt being the other 1/2. All you have to do then is put a nut on the bolt and tighten it down to form the dimple. It still distorts a bit, but even using machined dimple dies in a hydraulic press, my 1/4" plate distorted a little... nothing the press (or in the case of the thin materials used in rc, a ball peen hammer) couldn't handle. Works on lexan too! |
Re: Scale dimple tool Quote:
It can be straighten out by bend here and there, it's more work but not much. I haven't tried with heat but it sounds interesting. Quote:
|
All times are GMT -6. The time now is 05:44 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com