A little help needed with axles. I just got a set of CR-01 axles 2nd hand. They look to be in good shape, but the gears feel like hell when you just spin the pinion shaft. I opened them up, I can't see anything wrong or out of place (they look good inside too). Is this normal with these axles? Also, I did not get the outer bearings (the one right behind the pin and hex). Any one know what size that is? Thanks in advance. |
Make sure the pinion gear is shimmed properly, there should be at least 1 possibly 2 shims part #53587. The outer bearing is a 5x10, part #51239. Those are the part numbers right from the Tamiya manual. Hope this helps you out..."thumbsup" |
Thanks man"thumbsup" I will check out the shims and make sure they are right. |
All times are GMT -6. The time now is 04:17 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com