tlt bevel gear ???? does anyone know how wide the bevel gear shaft is on the tlt? |
Wide? The bevel gear is 13.5mm in diameter. The shaft is 5mm in diameter. The overall length is 25.4mm. Hope that helps. Rob |
ok, so the mip axial drivsshaft should fit on it then? |
I run the mips Quote:
Here's a tip: Remove the "e-clip" that holds the bushing/bearing in on the output shaft. It will not affect anything, and it will relieve the bind that the MIP shaft puts on the output shaft. If you have any question s on this, shoot me a PM. Good Luck & Happy Crawling |
Yes, the axial and tlt pinion shafts are both 5mm. |
All times are GMT -6. The time now is 12:25 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com