Revo shafts
 

I want to lengthen the links on my new TXT this weekend or next week. I saw something about using the Revo shafts when this is done, but somewhere I thought I saw something about using the Revo axle shafts, not the driveshafts.

Does anyone have any info on this? and if you have the part #'s that would be even better.

Mark

Re: Revo shafts
 

Here you go T-man. All the info you want on Revo's.

http://www.rccrawler.com/postt2497.html

Re: Revo shafts
 

Thanks Badger.

Is all I need the " 5451 --- Traxxas Drive Shaft Assy Revo " ?

That is all I see in the link, but I was also told that I might need all these other parts.

5450 - get 1 pkg ---- Traxxas Half Shaft Set L&R Revo ---
5452 - get 1 pkg ---- Traxxas U-Joints Drive Shaft Revo ---
5455 - get 2 pkgs ---- Traxxas Center Front and rear half shafts Revo ---

Re: Revo shafts
 

yep thats it. you can the parts seperately with those other #'s or complete with the #5451. just remove the pin the holds the steel stub axle in and pull the stub out. then use that yoke on your tranny with the mod Badger did.

its pretty easy as long as your WB is long enough.

Re: Revo shafts
 

I just ordered 2 packages of 5451 for $7 a piece.

I looked at the description of each while at the LHS and found out that 5451 was the complete set-up, and the others were all pieces.

BTW, these are Axle shafts, not the drive shafts. That was one of the questions I had.

Re: Revo shafts
 

P/N 5451 comes with these yokes
Here's a pic of the completed driveshafts.

http://img100.exs.cx/img100/4904/revshaft026af.jpg

This is a close up of the yoke INCLUDED with P/N 5451
It works with a TXT tranny from what I understand
http://img100.exs.cx/img100/7360/trac74536vl.jpg


The OTHER yoke is P/N 5458. Here's a pic
It works with a emaxx tranny b/c that is what I used.
http://img100.exs.cx/img100/9439/trac74585tf.jpg


Hope this clarifies things. 8)

Re: Revo shafts
 

Did you make any mods to fit the emaxx. I haven't been able to get them to fit without modding.

Re: Revo shafts
 

rckjeep, I had to drill the yoke to the size of the tranny's output and grind the end down flat. Takes 2minutes tops.