Dig servo BBQ Chime in if you have cooked a dig servo. just cooked one last night trying to get it adjusted correctly. wasnt paying enough attention to the dig shaft binding and kept adjusting for travel...damn i feel stupid. oh well there goes another 30 bucks. |
dont feel bad i smoked two till i got it right :oops: |
I made the mistake of assembling everything and THEN trying to set EPAs. Fried the first Hitec 225 real quick. |
Yep it happens. I smoked my 255mg setting the epa's. I learned quickly to set the epa's around 15-20 and start from there. On my setup I think I'm 20 one way and the other about 32ish. I run a home made servo mount like the rcbros, that's the reason for the epa #'s |
I set mine by having it not move and then upping the values till it was right. I am pretty sure that can be done on any remote but maybe not. At any rate you shouldn't fry any servos this way. |
Yep figured that out a little late...:lmao:i tore the servo apart and cleared up the solder that melted and it works in one direction now but with very little power. i figured i might as well try since i already got another on the way. |
I got luckey only stripped the gears. When I powered up with endpoints not set so I think I was luckey a 10dollar fix for new plastic gears. So hope everyone else doesn't have it so bad. |
ya i fried my 225mg when settin epas so what i did was unsolder the servos board and found an old digital servos board and wired it up and now its digital with no fears of it goin up in smoke |
I haven't cooked one yet but the epa adjustment is so touchy I was wondering if this wouldn't be an ideal place to use a servo saver? |
So I got my truck up and running tonight!:ror: I have an msx12, and I think that I burnt mine out. It still works but for some reason I can only handle two active possitions even when in 3 way mode on my dx3e. One possition is fully expossing the shaft of the gear. second position pushes that shaft all the way in:lmao:.... SEriously... then the next possition makes a sound but does not move the shaft any further because it cant move. But its yet to burn out. Any help from anyone? Then nice thing is I can still dig, just front dig. (front wheels move rear do not) Well thanks for the help, Ryan |
Ive burnt 4 hitec 225.Each time i think i have epa set right i burn another one,but hitec keeps sending a replacement(yaaaay Hitec)I finally did the battery tray trick and so far i havent had any problems |
Just toasted another one this morning. Damn. These things are touchy on EPAs. Was just trying to set them as far out as possible and.....Toast. |
All times are GMT -6. The time now is 12:23 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com