0 negitive offset wheels. (TLT OWNERS!!)

[DUDE]

Here is a way to get width for cheap. Most of us
know about the wideners and I think $40 range??
Well you have to buy wheels anyway so I am throwing
that cost out. But for the cost of some glue and $8 for another
set of rims you could have this.

Fist do the bead flip on the inside of Pede fronts on the inside bead.
refer to lil bitch biuld for that.
Then take a set of Pede rears and cut off the back right above the webbing. When your done you will have your extension.



Then take and slip into the lip on the outside bead on the pede front
after you narrowed in the back.



This is what your should have when fit up, then glue the extension on the out side lip on pede front with CA like a tire bead on the inside of new outer bead. When dry sand down the old outer bead sides and your done.



Here is a pick off the comparison against stock pede fronts with stock Masher 2.0's The tires I have on these rims are my own Masher 2.3 Crawlers.


Pic off the width now, much better @ 11.125"s.


close up of finished wheel @ 2.1875"s wide with 2.3 crawler.

[Tuffguy]

dood you kick arse , keep the ideas flowin man , feel it , work it like ya own it!
kevin

[toyofast]

Very nice write-up/how-to!

That TLT is way too clean... it needs some rock rash

[DUDE]

Originally Posted by toyofast

Very nice write-up/how-to!

That TLT is way too clean... it needs some rock rash

Thanks, I had some carnage today while testing the tires. The tires worked great and the cool part is when you wear the eges down too much just rotate side from side to side and a fresh egde is waiting. It just puts the reverse pattern on the inside.