| |
11-13-2007, 12:16 PM
| #1 |
| Quarry Creeper Join Date: Apr 2004
Posts: 271
|  M2K Reduction question
Hey guys, I'm in the process of reducing my M2K's from stock to narrowed down 1.9 tires. I'm already at the stage of narrowing the tire altogether so that it is the size of a 1.9 wheel, now comes the circumfrence change. I've seen a few of you that have done this mod, I'm just trying to figure out the best way to go about the cut through the tire. Any suggestions? It's my first time doing this so I'm not expecting perfection but I'm taking my time so that I can get the best possible result. Any suggestions would be greatly appreciated! Thanks guys
|
|  |
| Sponsored Links | |
| | |
|
11-13-2007, 04:17 PM
| #2 |
| Oppan Gangnam Style   Join Date: Jun 2005 Location: Shingle Springs
Posts: 5,164
|
Just follow the lug contour and down the sidewall.
|
|
| |
|
11-13-2007, 04:23 PM
| #3 |
| Rock Crawler Join Date: Feb 2007 Location: CoMo...Kickin it with Holmes Hobbies
Posts: 805
|
cut straight up from the inner bead and follow the lugs...basically cut in a "V" pattern...then cut 3 complete lugs off and your good to go...good luck..
|
|
| |
 |
| |
Linear Mode
