Radiolink RC6GS and diff locker config Hi all, newcomer to trx-4 family here. I constructed the chassis kit and upgraded electronics after some driving. I have this new radiolink rc6gs v2 transmitter and r7fg receiver. I'd like to hear how you others have configured diff lockers to work? I would like to have diff lockers work same way as the stock radio, both on one 3-way switch but I can't fiddle settings to do so. |
Re: Radiolink RC6GS and diff locker config Quote:
What you didn’t like about stock? Sent from my iPhone using Tapatalk |
Re: Radiolink RC6GS and diff locker config You will likely need to do the PMixing to mix the 2 diff lock channels and assign to one of the 3 way switches (5 or 6 chnl I think they are on the 3 way toggle switches. You can mix say cnl 4 with 5 or 6, so you can keep the 2nd toggle switch open, for winch as example. I don't have the TRX but I do have the radio link (just the v1 controller with te newest firmware, got it just a few months ago, shortly before the v2s with the handle buttons started shipping). Not sure of the settings needed to make it work from that point, but you will need to mix 2 of the channels to get both difs on one aux control. |
Re: Radiolink RC6GS and diff locker config Only the new RC6gs has a 3 way toggle. |
Re: Radiolink RC6GS and diff locker config I believe I have this figured out. check my post at http://www.rccrawler.com/forum/elect...er-config.html |
All times are GMT -6. The time now is 01:26 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com