Which aluminum hexes fit? I ordered some Axial wheel hexes with my TH in hopes that they would fit, but they do not. I ordered the weird ones with the protrusion on accident. Not a big deal, although I would like to find some that do fit. I'm not being too hard on my Hammers yet so the stock hexes and pins may last a while. I would prefer to have an aluminum set to install for peace of mind. |
Re: Which aluminum hexes fit? I drilled the centers on my hexes to fit the rear axle. 5/16 if memory is right will work. |
Re: Which aluminum hexes fit? Badger used the ones off the hpi mini trophy I believe ;-) they use the same pin size the twin uses compared to tamiya and axial |
Re: Which aluminum hexes fit? Quote:
Quote:
|
Re: Which aluminum hexes fit? The Losi MRC aluminum hexs will work but the centers need to be drilled out. |
Re: Which aluminum hexes fit? I tested fitted the Slash front tall hex units and they work plus they widen the front just a tad. Now I'm going to order the Proline Slash front aluminum hexes and run them at all four corners. Should have pics soon. Chris |
Re: Which aluminum hexes fit? Quote:
I hope they have set screws like the axial hex's do:roll: the wider pin slot will allow slop and break pins like they are going out of style. |
Re: Which aluminum hexes fit? Quote:
Pro-Line PRO-2 Front Clamping Hex 6097 for 2WD Slash |
Re: Which aluminum hexes fit? I picked up a set of HPI Blitz ones from RPP. They work great. HPI Racing Locking Hex Wheel Hub 12mm (4): Blitz |
Re: Which aluminum hexes fit? Quote:
|
Quote:
|
Re: Which aluminum hexes fit? I used the ones for a 4x4 slash, they worked fine for me |
Re: Which aluminum hexes fit? Not sure, but I bet the ones for a Mini 8ight will work...just need to be drilled out. |
Re: Which aluminum hexes fit? STRC also makes an alum. hex kit for the Slash 4x. |
Re: Which aluminum hexes fit? Ordered the HPI Blitz hexes last night. Thanks for the suggestions everyone! |
Re: Which aluminum hexes fit? The Losi Comp Crawler hex's will mount right up. Losi 12mm Aluminum Hex (5.7mm wide) (4): CCR (LOSA3186) "thumbsup" |
Re: Which aluminum hexes fit? Quote:
At least other folks can check this thread and see what their options are for direct-fit aluminum hexes. |
Re: Which aluminum hexes fit? Uhh...don't try Mini 8ight hexes. They're a no go, sorry for the bad advice. |
Re: Which aluminum hexes fit? I had a set of stock aluminium scx-10 hexes sitting around and used those, I only need to drill them out slightly. They also fit a lot tighter in the wheels than the stock plastic hexes. |
Re: Which aluminum hexes fit? Quote:
|
All times are GMT -6. The time now is 04:54 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com