DCW Wraith Servo Winch Mount http://i40.tinypic.com/w8ugbk.jpg I'm excited to present DCW's latest offering! Want a solid mount for your servo winch in your Wraith? I've got it! CNC cut from 6061, these mounts bolt directly to the frame using existing mounting points. No modifications needed. "thumbsup" http://i59.tinypic.com/qz3mkz.jpg Bolt in the winch... http://i58.tinypic.com/316s208.jpg ...and bolt the mount to the frame (installation instructions will be in the following posts). http://i58.tinypic.com/11uyl3a.jpg This mount tucks the winch low enough to stick a receiver or any other low profile electronic item on top of it, and back enough so that it is clear of the axle mounted steering servo. http://i61.tinypic.com/2h6ar2w.jpg Each mount is $12 + shipping, and includes all necessary hardware. DCW Crawlers - Home |
Re: DCW Wraith Servo Winch Mount Installation instructions: Check the servo ears to make sure the top sides are flat. If not, make them flat. Use a knife or file. http://i58.tinypic.com/1zcedxg.jpg Using the 3x8mm screws, nuts, and washers, attach the servo to the mount. http://i57.tinypic.com/okrklc.jpg Remove the two screws that hold the drivers side frame rail to the center support, replace them with the 25mm bolts. You may need to run a small drill bit all the way through to get them to go. Alternatively, you can open the holes up enough to allow the bolts to slip through instead of threading through. http://i62.tinypic.com/bhj41f.jpg Insert the bolts far enough to get the mount in place, then run them all the way in and instal the nuts. http://i58.tinypic.com/11uyl3a.jpg All that is left is to wire it up and go! "thumbsup" |
Re: DCW Wraith Servo Winch Mount Handy little piece |
Re: DCW Wraith Servo Winch Mount Pretty daggum spiffy there buddy. Very nice"thumbsup" |
Re: DCW Wraith Servo Winch Mount Looks good ,,Should hold servo winch in there ,,,"thumbsup" |
Re: DCW Wraith Servo Winch Mount Quote:
|
Re: DCW Wraith Servo Winch Mount Duuuuuuuude!!! Looks like my drill had some work to do.. On my TF2 and scx chassis! Great looking piece! |
Re: DCW Wraith Servo Winch Mount Have you tried it with a vp cms? Sent from the can using Tapatalk |
Re: DCW Wraith Servo Winch Mount Nope. I suppose it'd work if you drop the line down to run under the steering servo. |
Re: DCW Wraith Servo Winch Mount would it work with a winch with the spool on the outside ? |
Re: DCW Wraith Servo Winch Mount You mean with a spool attached where the servo horn would normally go? No. |
All times are GMT -6. The time now is 03:05 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com