dig unit help!!!! when i go out and craw its fine then when i installed the dig unit and try to crawl then the gears slip and when they dont my gears make a weird sound . so i dont know whats going on because its fine without it but when i instaled it its doing all theses weird things this is my second time intalling it and i lubed it really good and its still making all these problems:cry: |
Have you installed and set it correctly as per the instructions? Do you have a proper radio with EPA and 3 position 3rd channel? |
flip the dig fork 180 degrees i had the same problem"thumbsup" |
yea i have the radio for it its the stock one that came off the 2 stage setup and what do you mean about the fort 180 degrees i dont understand sorry |
1 Attachment(s) Quote:
|
ok well well i got it installed correctly but when i got it installed and was running it the gears where slipping really bad but i installed it right i looked at it so many times its so weird idk wat it is here this is what my crawler looks like your the firt people to see it just go to this link http://www.facebook.com/media/set/?s...83ecc69&type=1 |
Quote:
Check the trim and EPA settings on your radio for hte 3rd channel....adjust the servo settings and maybe adjust the servo itself until the dig works properly. |
Ok well is it able to take a lot of tork because i ran the dig on carpet and the gears slipped and when i run it on the hard florr it worked so is it supposed to take that much or is this normal? |
Not normal at all it can take as much torque you can give it |
Quote:
|
All times are GMT -6. The time now is 04:13 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com