traxxas drive shaft swap question

[idk]

ok ive searched and i think i got what i need just would like to make sure.


instead of the hardend steel versions can i use these Traxxas Heavy Duty Differential Output Yoke Set (2) [TRA6828X] | RC Cars & Trucks - A Main Hobbies

with these

http://www.rcplanet.com/Traxxas_Half..._p/tra1953.htm



shafts? i lost the pins and the inner piece that goes in the shaft today so i gotta do something but funds are tight and im not trying to spend 18 on output yokes alone



thanks

[venomcrawlerdud]

they will work just fine. the #1 most reccammended upgrade for a stock creeper is to change out the stock drive shafts. those shafts are also the ones that r reccammended by us creeper guys to swap to. all the guys run them and they work just fine.

one thing about the plastic yokes is dont tighten the screws to tight. they are very easy to strip out and then u have to get a new set.

[idk]

thank you sir im off to the lhs to fix my creeper!! woot woot

[rmdesignworks]

Originally Posted by idk

ok ive searched and i think i got what i need just would like to make sure.


instead of the hardend steel versions can i use these Traxxas Heavy Duty Differential Output Yoke Set (2) [TRA6828X] | RC Cars & Trucks - A Main Hobbies

with these

TRA1953 Traxxas Half Shafts Long Truck Pro Pak



shafts? i lost the pins and the inner piece that goes in the shaft today so i gotta do something but funds are tight and im not trying to spend 18 on output yokes alone



thanks

those are the wrong yokes...you need tra-4628x...the ones you show there are for 5mm shafts that need to be drilled for the yoke pins....not a good idea with 5mm out put shafts. As far as I know those yokes wont work with the tra1953 shafts. My steelys lasted almost two seasons...and I only replaced one complete shaft

[rmdesignworks]

i think the shafts you need for those yokes are 6850x

[rmdesignworks]

ask the lhs which traxxas yokes are for 5mm shafts...

[idk]

ok i didnt end up goin yet so that good thanks again for the info. so there isnt any plastic yokes that will work or do just need to get the #6850x shafts?

[rmdesignworks]

double check with your lhs but I think so....

[idk]

went with traxxas 4628x and 4628r with the half shafts from above. my budget wouldnt allow two set of 4628x but im up and crawlin no issue yet thanks for the help

[rmdesignworks]

Originally Posted by idk

went with traxxas 4628x and 4628r with the half shafts from above. my budget wouldnt allow two set of 4628x but im up and crawlin no issue yet thanks for the help

Keep us updated on the yokes man...Im curious how they do.