Anyone know? Will these work on the Axial shock shafts? I'm looking to get a little more ride height but I do not want to change the shock location. http://www3.towerhobbies.com/cgi-bin...?&I=LXKMD6&P=7 |
Yes, they do. I used them on a tuber I built. |
1 Attachment(s) Update - These rod ends WILL NOT WORK on 3mm threads which is the thread size of the shock shaft. I only have calipers at home, and this is not really the best way to measure, but you can see the id hole is huge! See attached pic. Long story short, I did some searching on McMaster and picked up some standoffs. I decided on nylon to start, and turns out that after the beating on Sunday (A few 3+ foot falls!), they will work great! Cheers! |
Sorry about the bad info, there. I should have read a little more carefully, because I used a set of Stampede rod ends. |
Hmmm the Dubro HD 3mm ends are 10mm longer than the stock rod ends. How ever it looks like you fond a fix for it. |
All times are GMT -6. The time now is 06:30 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO ©2011, Crawlability, Inc.
Copyright 2004-2014 RCCrawler.com