| |
| |||||||
 |
| | LinkBack | Thread Tools | Display Modes |
09-11-2008, 02:20 PM
| #1 |
| Rock Stacker Join Date: Sep 2008 Location: NYC
Posts: 68
|  X-Factor axle shaft grub screws
Anyone know of a better solution to keep these things from spinning out? I've used loc-tite several times, and after a couple of runs have noticed that they've backed out again. It's starting to get annoying; having to take apart the front and rear axles after two-three runs is a pain. Are there one-piece axle shafts available that don't use a separate screwed collar to attach to the differential output shafts?
|
|  |
| Sponsored Links | |
| | |
|
09-16-2008, 04:36 PM
| #2 |
| Rock Crawler Join Date: Mar 2005 Location: Murrieta
Posts: 806
|
weld or braze them. youll have to take the black oxide coatin off but they wont come apart again after you weld em  |
|
| |
|
09-27-2008, 03:53 PM
| #3 |
| Quarry Creeper Join Date: Apr 2008 Location: Fondy, WI
Posts: 498
|
are you using red or blue loctite? red loctite is pretty permanent... you have to heat the srew/bolt in order to get it out.
|
|
| |
|
09-27-2008, 03:54 PM
| #4 |
| Quarry Creeper Join Date: Apr 2008 Location: Fondy, WI
Posts: 498
|
other than that issue, what do you think of the crawler?
|
|
| |
|
| |
Linear Mode
