Link sets and drive shafts

[dbw]

Is anyone producing full link sets or drive shafts yet? I haven't seen anything from VP on the links and I'm hoping MIP comes out with a drive shaft rather than piecing things together from 2 other kits. I read someone on here about links but can t seem to find it. I need to order some.

Thanks and sorry if this is repetitive

 

[ostewart]

Dlux do link sets

 

[altd896]

Is anyone producing full link sets or drive shafts yet? I haven't seen anything from VP on the links and I'm hoping MIP comes out with a drive shaft rather than piecing things together from 2 other kits. I read someone on here about links but can t seem to find it. I need to order some.

Thanks and sorry if this is repetitive

Yeti & Wraith parts
VPS07201 - Vanquish Yeti Rear Upper Links Kit – CKRC Hobbies
VPS07350 - Vanquish Yeti Rear Trailing Arms - Black – CKRC Hobbies
VPS03135 - Vanquish Axial Wraith 3:16 Titanium Lower Links – CKRC Hobbies
VPS03136 - Vanquish Axial Wraith 3:16 Titanium Upper Links – CKRC Hobbies
VPS03122 - Vanquish Axial Wraith Drag Link – CKRC Hobbies
VPS03111 - Vanquish 3:16 Ackerman Tie Rod - Wraith – CKRC Hobbies
MIP14390 - MIP X-Duty Rear C-Drive Kit Yeti Driveline – CKRC Hobbies
MIP08101 - MIP C-Drive Spline Set AX10 Scorpion SCX-10 – CKRC Hobbies

 

[Alexander_0_1]

If anyone is curious, the super rebuildable punisher shaft for the scx10 rear/wraith front fits the front of the bomber, also the super rebuildable punisher shaft that fits the wraith rear fits the rear of the bomber if your currently using an offset axle (it too short for centered).

The front fits nicely, while the rear only has 'bout half the engagement between the male/female bones.

 

[Joshs4x4toyz]

If anyone is curious, the super rebuildable punisher shaft for the scx10 rear/wraith front fits the front of the bomber, also the super rebuildable punisher shaft that fits the wraith rear fits the rear of the bomber if your currently using an offset axle (it too short for centered).

The front fits nicely, while the rear only has 'bout half the engagement between the male/female bones.

"thumbsup" Same I did for front but have centered rear and used a yeti MIP. Very close but never touches cover.

 

[Alexander_0_1]

"thumbsup" Same I did for front but have centered rear and used a yeti MIP. Very close but never touches cover.

Yea, I didn't want to grind anything off of the chassis, or the r/x box so I tried every driveshaft in my bins."thumbsup"