4pks and winch issues

[K1llerRC]

Ok, im sure its somewhere in the thousands of pages somewhere here on forum, buuuutttt, I cant seem to find it. So either a link or some sure helpful advice would be great.

I have a Futaba 4PKS and cant seem to figure out a 3 position set up for my 4th channel which I have dedicated to my RC4wd winch and cant seem to find a neutral on PS1.. Im running the BEC through my battery channel, my servo on std 1st, esc on 2 and shift servo on 3..

Any tried and true advice would be great.

 

[northernerbill]

Be warned the winch running on ch3 may start to wander, ever so slowly but wander it will.
I now use the wireless controller. You might need to control it from a second esc

 

[Travis24vctd]

You might just need to adjust the small dial on the winch controller that plugs into your receiver. After i switched to a four channel rx and tx i had this issue. Adjusted the lil dial works perfect. It might have a dab of silicone over the dial but is easy to remove and adjust. Its the small blue plastic piece that sticks through the heat shrink that's around the microchip.

 

[K1llerRC]

Thanks guys, ive adjusted the sh-t out of that winch controller, and since have installed a Hayok non drift modual. I do believe it is just my lack of experience with the 4pks,