Axle width (WMS)

[TacoCrawler]

searching was of no help
or I just suck at that

I need to know the axle width on the Wraith...
WMS and also measured to the outside of each tire.

Can this axle be made even wider ?
if so... how much width might be gained
and using what method ? (extra length beef tubes ? other ?)

if you know... or can measure that for me...
I would appreciate your assistance.

thanks.

 

[Billy D]

Google axial wraith PDF. And it will give you all the specs on everything. http://docs.axialracing.com/instructions/ax90020-i002-wraith-kit.pdf. Sorry i grabed it for ya.

 

[TacoCrawler]

Thanks for the pdf link...
something is wrong with my pdf program launch...
as it's taking forever to load

I'll have to go to my laptop and see if it loads better there.

 

[Harley]

Google axial wraith PDF. And it will give you all the specs on everything. http://docs.axialracing.com/instructions/ax90020-i002-wraith-kit.pdf. Sorry i grabed it for ya.

I don't think that has any info on WMS distances or track width.

I don't have my truck handy at the moment or I would measure, I might have it posted in one of my other threads though.

As far as width. You have a couple options but it would require fabrication of axle shafts and/or housings. You could cut the short side off, sleeve it and add on another log side from another housing. You could match the long side length if you liked to no have to run custom shafts.

You could buy Vanquish Currie axles and buy two long side tubes and run long side shafts to not have to do any modifications. You could also run the SCX10 truss instead of the Wraith truss to tie it all in, but that may require a couple holes to be drilled and tapped in the tubes.