Bully 2.2 Black Delrin Inverted Servo Mount

[Culetto]

I dont even want to think about how hard you would have to land on this thing to break it. Its beef!

 

[hairumuffin]

Does he still makes these?

 

[xirtic]

Does he still makes these?

Yes....I still produce these mounts. I am currently out of stock and awaiting a shipment from my machinist. I keep stock-status and estimated re-stock times on the first post of this thread. Please check back in about a week. Thanks.

 

[dleigh007]

I know this thread has been dead for a while, but I just found my old Bully axles and found that I have two front axles but only one servo mount. Do you still make these servo mounts?

If not, does anyone make servo mounts for the Bully axles?

Thanks,
Deven

 

[mikemcE]

Dravtech
Find them at Dlux

https://dluxfab.ecwid.com/#!/Bully/c/11553002/offset=0&sort=nameAsc


Hang up and Drive

 

[Evo93]

Those are for bully 2 not sure it fits original bully

 

[mikemcE]

Nor I, but it's a start


Hang up and Drive

 

[dleigh007]

What are the dimensions of the servo plate? Does anyone know?

https://dluxfab.ecwid.com/#!/Servo-mount-Bully2-Dravtech/p/76472615/category=11553002

Does it fit the Bully 2.2 front axle?

 

[dleigh007]

Or can someone that has the Bully 2 axles measure the distance between the servo mounting holes for me?

Thanks

 

[Evo93]

Or can someone that has the Bully 2 axles measure the distance between the servo mounting holes for me?

Thanks

I'm not next to my rig. But I believe the holes are the same width as a servos mounting holes. Just slightly offset from the holes that hold the servo to get it closer to the gear case. Might have to flip it as the gear case is on the opposite side on the original axles. If the offset doesn't work the original bully 2 mount is straight and you can get it from rc4wd.

 

[xirtic]

I know this thread has been dead for a while, but I just found my old Bully axles and found that I have two front axles but only one servo mount. Do you still make these servo mounts?

If not, does anyone make servo mounts for the Bully axles?

Thanks,
Deven

Unfortunately I no longer am in the production side of the hobby. I do not have any remaining stock, nor can I produce any more at a fair cost as I sold off my CNC Mill as I was not using it anymore.

Josh

 

[barberton crawler]

hay josh are you still making these if so can you send me a pic I don't have access to the vendor section here yet

 

[Evo93]

hay josh are you still making these if so can you send me a pic I don't have access to the vendor section here yet

Look at the above post..