Help with Hack on GT3B Trans... Local to NH Please

[NHebayer]

I just bought a Fly Sky GT3B radio.... I have ordered the Hack kit from Overkill.

I can do the physical installs and the soldering of the Plug.. New VR.. Lipo ...Bearing etc... But I'm worried about the programing.

The more I read.. the more confused I get. I need help.

Is there anybody local to NH or Northern Mass... or VT that has done the hack and can help me with the programming & Teach me how to run it after??? If I can find someone local... I will gladly pay you for your time.

Or... is there a HACK FOR DUMMIES thread?? I need step by step... click by click directions... How to install the Programming hack.. them how to set up 4 channels for my Crawler.... Throttle.. Steering... Dig... 4WS.. on my Ax10 Scorpian.

Can you help?

 

[losikid]

You should of got an email with your order that had alot of good resources in it to read...

 

[NHebayer]

You should of got an email with your order that had alot of good resources in it to read...

Yes... I did. But as I already said. The more I read.. the more confused I become.

I am new to the RC world... and not good with computers.

I'm hoping once I get the parts installed and plug it in... it will make more sense... But right now I'm pretty much lost.

 

[Hobine]

I was surprised how easy the hack was. Follow the directions and you'll be OK. I'm in MA if you get really stuck. Only did one radio so far but everything went very smooth.

 

[m1009cucv]

looking at the manual is confusing me a bit too. no very little about this stuff. the 3rd channal on my remote is not working

 

[NHebayer]

went to use my gt3b today for the first time and the reverse was not working very well.. try rebinding or calibrating to esc and now its not working at all. esc does not et a reverse signal... so it wont calibrate.
very frustrating