HiTec X2 Plus Charger issue

[Digital]

So I'm trying to setup the memory for different battery packs.

On Prog. A, the memory works corrrectly and shows 2.2A.

On the 2nd port, (Prog. B), I have the memory set for 4A (4000Mah 2S). When I switch to LIPO mode it shows 2.0A??

No batteries are connected, what am I doing wrong?

 

[mikemcE]

Most likely nothing, the second port is set to give 80% of what the first is. I don’t think that can be reconfigured


Hang up and Drive

 

[Digital]

Most likely nothing, the second port is set to give 80% of what the first is. I don’t think that can be reconfigured


Hang up and Drive

Hey Mike, I don't know whats going on, apparently it's doing the same thing on Prog A...

Just so I'm not crazy, if I'm going to charge a 2S 4000mah battery, I do that at 4 Amps correct? Discharge also at 4 Amps? Discharge voltage at 3.3v? Maybe my settings are wrong and it's a safety thing or something...I dunno.

"Adjustable Charge Current Rate of 0.1 – 10.0 Amps Each Port"

 

[mikemcE]

The built in program is set .
When charging thebattery as stated you are correct, but if you try two at 4000, the second is maxed at 80%. This is from memory of the manual


Hang up and Drive

 

[Digital]

That's my problem i think Mike, I go to the memory setting and hit the enter key on the memory setting that I configured but it doesn't load or I'm doing something wrong here.

Sent from my Tin Can using Tapatalk

 

[mikemcE]

Re read the Bible. I actually have it on my phone so when i go to charge batteries, I’m always set.


Hang up and Drive

 

[Digital]

Apparently if you press the Enter key briefly, it sets the configuration for that Memory setting, then if YOU HOLD ENTER for 3 seconds it applies that selected memory setting...

Either I had too many beers last night or I'm just retarded....maybe both. But it's works as intended now. "thumbsup"

 

[mikemcE]

That’s why I made mine beep......... keeps me thinking?


Hang up and Drive