kyosho drx ve / Team Orion Vortex R10 ESC question

[phase10]

Hey i am curious if i have to change anything to run a 3s in my drx ve? if so, a little help would be nice because the manual it came with kinda confuses me. thanks!

 

[team_guahan]

you dont need to change anything to run 3s. I know the outside of the box says you can and the team orion vortex is rated for 3s. "thumbsup" have fun

 

[phase10]

you dont need to change anything to run 3s. I know the outside of the box says you can and the team orion vortex is rated for 3s. "thumbsup" have fun

i know it can handle 3s, just not sure if i had to set it for 3s so it worked / the auto lipo cutoff worked..

 

[team_guahan]

Yup the car work great with 3s. I didnt change anything.

 

[phase10]

Yup the car work great with 3s. I didnt change anything.

thanks! i dont wanna start a new thread,, but we should petition for proline to make us some tires and wheels"thumbsup""thumbsup""thumbsup""thumbsup"

 

[Stburr91]

thanks! i dont wanna start a new thread,, but we should petition for proline to make us some tires and wheels"thumbsup""thumbsup""thumbsup""thumbsup"

I've heard that these tires fit on the stock DRX wheels.

Pro-Line Road Rage 2.2" Street Tires (2) [PRO1102-00] | RC Cars & Trucks - A Main Hobbies

http://www.amainhobbies.com/product.../5511/n/Pro-Line-Dirt-Hawg-I-22-Buggy-Tires-2



I ordered some Road Rage tires, so I'll post up how they work out.

 

[cbp27]

I would be careful with the factory default settings on the Orion ESC. I am also running that ESC but had to change some of the settings for safey.

Here are the stock settings. The chart can be found on page 20 in the manual.
1. Forward/Reverse with Brake
2. Drag Brake Force 5%
3. Low Voltage Cut-Off Threshold 2.6V/Cell
4. Start Mode (Punch) Level 3
5. Max Brake Force 75%

If you are running lipos I recommend changing #3 to at least 3.2V/Cell or higher. 3.0 Volts per cell is the lowest you want them to drop to. But for the chance that some may be unbalanced and lower than the others, your cut-off voltage should be 3.2 at the lowest.

You can find instructions for adjusting the ESC from page 20-22 in the manual. I agree it's not the easiest manual to read but it's not too difficult. I've been using this Orion setup and it's been working fine so far on 3S. Hope that helps. "thumbsup"

 

[MG200]

If anyone is having trouble with the manual included try the one direct from Orion. It is easier to understand.

Controllers :: Brushless Controllers :: 1/10 Sensorless :: Vortex R10 Sport Brushless ESC (45A, 2-3) - Team Orion

 

[Stburr91]

If anyone is having trouble with the manual included try the one direct from Orion. It is easier to understand.

Controllers :: Brushless Controllers :: 1/10 Sensorless :: Vortex R10 Sport Brushless ESC (45A, 2-3) - Team Orion

Thanks man, that does help.