My new Bully 2 (pictures)

[Meir]

My new bully 2- [emoji41]

Bully 2 chassis stock.
Axial aluminum shocks.
Servo hitec 7950.
55t dual tekin.
Fxr dual.
HB rover tires.

I think i make mistake with the shocks because thay are to long for the chassis, what do you think?

I need something else for the engines 55t and the fxr or i can install it like this?

What chassis you recommend?

Something else that i can install i would love to hear!! [emoji3]

Thank u very much [emoji5]

Sent from my LG-H815 using Tapatalk

 

[ElChupacabra]

If the shocks are too long you can limit their travel internally with RC fuel tubing or I use aquarium air hose around the shaft. It will sit the rig down a bit and also limit the flex if you have too much flex.

 

[Meir]

Sorry but my english not so good i understand what is a fuel tube but where am i stuck im?

Sent from my LG-H815 using Tapatalk

 

[mikemcE]

Take the shock apart, put a spacer under the piston and reassemble shock the thickness of the spacer will lower the vehicle and eliminate some shock travel


Hang up and Drive

 

[tapped-out]

I'd run the rc4wd 35t motors I see in the rig.. and sell the 55t tekin motors. if you like tekin go with their 30t or 35t motors.

 

[Meir]

Thanks all of u so much helpful!

Sent from my LG-H815 using Tapatalk

 

[cabron]

after you put the silicone tube under the piston and reassemble the shock,
it will be shorter. might need to back off the adjustment nut on the preload if you
feel the suspension is too stiff.

agree with the fxrs being good and faster motors, 35t is ok
3s lipo battery will be nice too

have fun in the sand