Panda Hobby - Tetra X2 throttle reversed?

[MicroCrawlin]

Hi everyone!

I own a few SCX24s and Mini-Z’s but I just picked up a Panda Hobby Tetra X2. For some reason straight out the box the the throttle is reversed. Is there a way to adjust this that I’m missing? I’ve googled, YouTube’d and read the manual. I can’t figure out if the motor was just soldered in wrong or what. The lights function correctly.

Thanks for any advice!

 

[OnTheTrail]

Not familiar with that rig my self but is there a way to reverse the servo on the transmitter? Sometimes there's a slider switch on the remote.

 

[89lxmorepower]

Unplug motor connector at esc carefully lift tabs retaining wires and reinstall opposite of factory and will fix your issues

 

[MicroCrawlin]

Thanks for the replies. There isn’t a throttle reverse switch on the transmitter unfortunately. So, It looks like I will have to reverse the wires. I was hoping there might be some transmitter trick similar to the traxxas or kyosho transmitters that could change settings by either holding the trigger or a button combo, but this must just be a mistake by Panda Hobby and they didn’t QC it before sending it out.

Overall it’s a pretty sweet rig. Hopefully it holds up as good as my SCXs

 

[89lxmorepower]

I have one myself it is a neat rig but ya wire swap is like 30 seconds and done no biggie

 

[MicroCrawlin]

Just wanted to say thanks again. The wire swap was easy enough and this little thing is fun.