VR6 BeelzeDub
Quarry Creeper
Does anyone make an insert to cap the front of the Mojave bed? Similar to the cab back panels I.e. Loops, RC4WD, 3D printed stuff etc...
I want to reduce the wheelbase on my project by about 4-5mm and removing the bed mounting tabs (that attach inside the cab) would be the cleanest solution. I would leave about an o-rings width gap b/w cab and bed.
I’ve seen build threads in the past where they’ve been made out of styrene but can’t seem to find any.
Please feel free to share your handy work or info you may have!
Sent from my iPhone using Tapatalk
I want to reduce the wheelbase on my project by about 4-5mm and removing the bed mounting tabs (that attach inside the cab) would be the cleanest solution. I would leave about an o-rings width gap b/w cab and bed.
I’ve seen build threads in the past where they’ve been made out of styrene but can’t seem to find any.
Please feel free to share your handy work or info you may have!
Sent from my iPhone using Tapatalk
Just had a thought, maybe buy a second cab back piece to trim up and glue in?
