Has anyone run a Sidewinder on 4s lipos? I would be running a BEC and 2 - 2s lipos in series. Looking to run it on a 55t motor. It is rated for 12 cells nimh but only says 3s lipo. I would think that the 55t motor would not draw to much to smoke it.
-
Welcome to RCCrawler Forums.
It looks like you're enjoying RCCrawler's Forums but haven't created an account yet. Why not take a minute to register for your own free account now? As a member you get free access to all of our forums and posts plus the ability to post your own messages, communicate directly with other members, and much more. Register now!
Already a member? Login at the top of this page to stop seeing this message.
Sidewinder on 4s?
- Thread starter Mic
- Start date
Brainstain
Nope..
Post pix of the fire...
cspyy
Rock Crawler
kamikaze told me it would be fine with 55t lathes and my mamba max.
i will find out this weekend, got a 4800mah Elite 4s sitting in the skid plate of my clod on standby:twisted:
i will find out this weekend, got a 4800mah Elite 4s sitting in the skid plate of my clod on standby:twisted:
Well I did it. Now I am ruined, no way I can go back to running a 2s setup"thumbsup" I set the BEC up at 6.4 volts and mounted the 2 packs on the axle/servo tray I made. Still has the low speed control of the 55t and the insane power of 4s. I am running 2 1450mah 25c hypieiorn packs which fit nicely over the axle.
Yeah, 4s is my new standard as well. It is reaaaaly hard to go back to low voltage after pumping some juice into these motors.
I was able to make some lines that I was not able to make before. It may cause me to get lazy and just power though the harder stuff and I am sure I will start to snap some things that I never thought I would. But on the flip side it is pretty darn fun!
